文章摘要
引用本文:李崇,宋大雷,宫宜辉,杨华,李坤乾.谐振式陀螺全角模式误差来源与接口技术[J].导航与控制,2019,(4):33-38 本文二维码信息
二维码(扫一下试试看!)
谐振式陀螺全角模式误差来源与接口技术
Error Source and Interface Technology of Resonant Gyroscope with Whole Angle Mode
  
DOI:
中文关键词:  微机电陀螺  半球谐振陀螺  全角模式  角速率积分陀螺  惯性传感器
English Keywords:micro electro mechanical systems gyroscope  hemispherical resonator gyroscope  whole angle mode  angular rate-integrating gyroscope  inertial sensor
基金项目:
作者单位
李崇 中国海洋大学工程学院青岛 266100 
宋大雷 中国海洋大学工程学院青岛 266100 
宫宜辉 中国海洋大学工程学院青岛 266100 
杨华 中国海洋大学信息科学与工程学院青岛 266100 
李坤乾 中国海洋大学工程学院青岛 266100 
摘要点击次数: 6
全文下载次数: 8
中文摘要:
      全角模式是谐振式陀螺的新型接口技术,具有直接测量角度、动态范围大的优点,但其对陀螺元器件对称性要求极高的缺点限制了它的实际应用。首先,从谐振式陀螺全角模式的原理出发,讨论了各种不理想因素对全角模式运行造成的问题。然后,从器件设计和控制系统两方面出发,讨论了可行的技术路线。最后,通过数值仿真的方法证明了理论分析的正确性,并给出了谐振式陀螺的选型和控制系统的建议。
English Summary:
      The whole angle mode is a new interface technology of resonant gyroscope, it has the advantages of direct measurement of angle and large dynamic range. However, its high requirement for symmetry of gyroscope components limits its practical application. In this paper, based on the principle of whole angle mode of resonant gyroscope, the problems caused by various unsatisfactory factors in the operation of whole angle mode are discussed. Then, from two aspects of device design and control system, the feasible technical route is discussed. Finally, the correctness of the theoretical analysis is proved by numerical simulation, and suggestions for the selection and control system of resonant gyroscope are given.
查看全文  查看/发表评论  下载PDF阅读器